IMPORTANT
Keep the metal screws of the old OEM adjusters and insert them into the new plastic
bits.
Removing the adjusters
Two of the metal bits are the actual adjustment
screws (middle & right) and just screw into the plastic parts by self cutting their necessary thread.
You need to grab the plastic part on the non threaded part with some appropriate pliers to screw in
the metal screw.
The third one is quite a bit shorter and has to
be pressed into the plastic part.
This is the best way to do it – watch out for
the 2.6cm and put the nut on the thread prior to putting it into the vice !
The small pins on the plastic bits are
preventing them from turning while adjusting the headlight later.
This is what it looks like when you’re done